moorlandbushcraft I exclusively modify the 91mm knives. Personally I'm only interested in the Victorinox tools for the knives I put together. Stock aluminum liners or aluminum liners I've made/modified too. I do swap tools into layer combinations that don't exist with factory knives.
A lot of this stuff just has to be learned the hard way but the good thing is you can always pull the knives apart and try again. Lots of knives look the part in pictures but have real issues in person. Tools aren't shimmed when they should be or the wrong spring or liner was used, etc.
That's one thing that gets over looked a lot are liners. Using the correct liner is often really important. You also work through the same issues Victorinox has over the years when you swap parts around.
One problem can be seen in your pictures of the knife on the right. The philips layer needs to have clearance with what ever's next to it. In this case the builder has been forced to ad a second liner on each side of the philips tool. The liner needs to look like a canoe or something else that has a cut away. If you don't do that the philips will make contact with either the tool next to it or the liner otherwise. I'm sure many are familiar of certain models that have a nick out of the aluminum liner next to the philips. That layer philips/flashlight or philips/magnifying glass always need special liner consideration. There are others like that too.
Careful planning is often needed to place tools next to each other so you don't need to use spacers or second liners. Sometimes it just can't be avoided though.